9
English
Warning: When mounting or
removing the radio, handle
carefully the connectors to
avoid damages.
Replacing the fuse
1- Remove the fuse F from the connector block
at the rear of the radio.
2- Replace it with a new 10A blade-type fuse
Note 1 :
The new fuse must be of same value
and same type, otherwise the set will not be
adequately protected.
Note 2 :
If you do not follow this procedure,
you risk damaging the set which invalidate the
guarantee.
Suppressing Interference
Most modern cars have adequate interference
suppression. If you experience interference,
consult your garage.
Using Remote Control**
As an accessory, you can use two types of
infrared to remote control your set:
1- Credit Card Format.
2- Steering Wheel.
Installing a subwoofer
As a major element of your sound reproduction
system, you can install a subwoofer.
With an external amplifier (see Fig.8):
a/ connect the subwoofer speaker on an
external amplifier, then connect this one on
D2 (Pin 23: subwoofer output).
b/ Select a low frequency threshold in the
Sound Init Menu: 40 or 80 Hz.
Note 1 :
Before using the subwoofer, you can
adjust its volume in the Sound Menu.
SECURITY
FRONT
Removing the front
1- Press the REL key.
2- Pull the front towards you.
3- Take the detachable front with you when
you leave the car.
4- Keep the front in its protective cover.
Replacing the front
1- Put the right side whole of the front into
the socket of the set.
2- Push the left side of the front into place
until it clicks into position.
Note 1 :
If you hear a warning signal, the front
is not properly replaced.
Note 2 :
To ensure good connection between
the set and the detachable unit, it is advisable
to clean carefully the connections with a cotton
swab from time to time.
WARNINGS
Warning LED
When the engine is switched off and the front
is removed, the warning LED flashes.
You can switch off the warning LED (see SAM
menu, Warning LED function).
!
** For this accessory, contact your dealer.
AN2001-2L-Eng.pm7
11/20/02, 3:32 PM
9
