8
Output Subwoofer Amplifier
Use these interfaces (Pins 22 & 23) to connect
a subwoofer amplifier.
Connect Blue wire (A5) to Amplifier Remote
on/off.
Note :
Before using the subwoofer, you need
to switch it ON and select its low frequency
threshold in the Sound Init Menu, and adjust
its volume in the Sound Menu.
Audio In
Use these inputs (Pins 24, 27 & 28) to connect
other auxiliary audio equipments.
Navigation mute
Use this input (pin 26) to connect your
navigation system mute signal.
Note :
Before using your navigation system,
you need to set the navigation system and to
configure its appropriate detection level in the
SAM Menu
MOUNTING
METAL SLEEVE
1- Insert the metal sleeve in the opening
(182x53mm) of the car dashboard or
console (See Installation card, Fig.11).
For CD Player optimal performance, the
metal sleeve must be positioned within
limits shown: angle between 0° to +30°.
2- Fix the sleeve by pushing the metal tags
outwards with a screwdriver (see Fig.11).
CAR RADIO
Connecting the radio
(See Fig.9 and Fig.10)
1- Check that the battery is disconnected.
2- Insert antenna connector E in the antenna
socket (good reception is only possible with
a good antenna) : use the antenna adapter
if necessary. Use the J hook on the back of
the set to secure fixing.
3- Insert the power supply connector in socket
A7.
4- Insert the loudspeakers connectors in socket
B (B1 to B8).
(optional) Remove the protective cover
from socket C.
(optional) Insert the yellow line-out
connector in socket C1.
(optional) Insert the blue connector for the
CDC in socket C3.
(optional) Insert the green connector in
socket C2. The green connector fits
between yellow connector C1 and blue
connector C3. You need at least one of
these connections to keep C2 in place.
Mounting a DIN radio
(See Fig.12)
1- Slide the radio into the metal sleeve until
the springs on either side snap into the
sleeve openings.
2- Reconnect the negative terminal of the car
battery (see Fig.15): the installation is now
complete.
Note :
The buffer mounting, directly mounted
on the back side allows safety tenure.
Mounting a JIN radio**
(See Fig.13)
1- Remove the frame front of your radio.
2- Insert your radio through the back side of
the dashboard until the brackets on either
side fit with the screw holes..
3- Screw both side of your car radio with the
M5 x 6 mm max. length screws.
4- Mount the frame front.
5- Reconnect the negative terminal of the car
battery (see Fig.15): the installation is now
complete.
Removing the radio
(see Fig.14)
You can unlock the radio using the two left
and right U-brackets provided.
1- Check that the battery is disconnected.
2- Remove the front.
3- Insert each well positioned U-bracket in its
corresponding side socket until they lock.
4- Remove the radio from the metal sleeve.
** For this accessory, contact your dealer.
AN2001-2L-Eng.pm7
11/20/02, 3:32 PM
8
