5
NOTICE
The wall mount fasteners included with this fireplace are for use ONLY with a
wood-framed wall covered in drywall (sheet rock). For concrete walls, cinder
blocks, or other wall types, consult a professional for the best attachment methods.
ALWAYS unplug
this fireplace heater
before assembly
or
cleaning, or before
relocating.
Failure to do so could result in
electric shock
,
fire
, or
personal injury
.
STEP 2.
A. Locate the wall studs using an electronic stud-finder. B. The two outer screws should
be screwed into a wall stud, and the center screw into a drywall anchor. C.
If only one stud is
available, the center screw MUST be screwed directly into it
, and the two outer screws may be
screwed into the drywall anchors. D. Mark the hole locations with a pencil. The holes should be 8”
(20.3 cm) apart, and level. The minimum height from the surface below must be 75.2” (191 cm).
AVOID INJURY and DAMAGE! The center screw must
be screwed
directly into a wall
stud
. The two additional screws may
be screwed into the drywall anchors
.
STEP 3.
Drill a pilot hole into each mark using a 1/4” wood drill bit for the drywall anchors, and a
1/16” wood drill bit for the wall studs. With a hammer, tap the drywall anchor(s) (C) carefully into
the hole(s) until they are flush with the drywall surface. Use care to avoid damaging the drywall with
the hammer.
Drywall
Studs
C
C
C
