®
®
1.51
1.61
1.62
1.63
1.64
1.65
1.66
Connect the Protective Earth Terminal D on the RF
Distribution Module to the building Protective Earth System
if required.
Check the resi-linx IR Modulator is connected to the
Modulator MOD RF IN input E on the RF Distribution
Module.
From the wall socket, connect a coaxial fly lead to the
System Input on the IR Target.
From the TV output on the IR Target, connect a coaxial fly
lead to the TV.
Steps 1.62 & 1.63 can be repeated for up to 8 TV outputs
around the premises. NOTE: If an IR Target is not used,
an in-line DC block should be used.
Connect IR emitters (RL-IR700/800) to the outputs on the
rear of the IR Modulator. Place the emitter head 10mm to
either side of the IR receiver of the AV source (depending
on environmental conditions).
If required, connect either Single or Double IR Emitter (RL-
IR700/800) to the IR Emitter Port H for local control of
AV source.
1.5 Protective Earth Terminal
1.6 IR Connection
No of RF output
8
No of RF input (2 x Modulator/1 x ANT)
3
IR pass back
Yes
IR emitter port
Yes
Output Freq
37-850 MHz
RF Gain/Loss - ANT
+2dB
- Modulator +3dB
RF Output run distance
60 metres
Isolation (Modulator inputs to ANT) -80dB
Power requirement 12V DC feed in by remote
power or DC plug pack
Size (mm)
163(l) x 39(h) x 69(d)
WARRANTY
Vcomm Pty Ltd states that the warrant that the customer can rely on is that
provided by the manufacturer. In the event of any warranty claim please
contact us and we will forward it to the manufacturer. The manufacturer will
then determine the extent of their liability. This expressly negates, to the
extent possible by Australian law, any warranty reliance on Vcomm Pty Ltd.
ABN: 99 091 281 524
Vcomm Pty Ltd
www.resi-linx.com
Patented
N15275
by
RL-RF380
Radio Frequency Range
resi-linx
RF Distribution Module
¸
1.71
1.72
In the event of FM interference affecting TV channels
switch I to ‘ON’ position.
NOTE
- When ‘ON’ FM radio frequency will be blocked to
all outputs.
1.7 FM Trap Switch
