VC 12540, Инструкция по монтажу и эксплуатации

Страница: 33 / 84

31
5.4. Trigger Type
There are two trigger types: “Initial Trigger” and “Continuous Trigger” for selection.
Initial Trigger: When channel has been triggered, it will display on full screen as
the setting time period. In that time period, this channel will ignore any other
trigger.
Continuous Trigger: When channel has been triggered, it will display on full
screen as the setting time period. In that time period, this channel is still watching
out. If another trigger act, the channel will display on full screen and count all over
again by the setting time period.
5.5. Motion Setup
To setup motion detector configuration
5.5.1. Motion Mode
To select the motion sensitivity scale as “Sensitive OFF”, “Sensitive Low”,
“Sensitive Normal”, “Sensitive High” or “Sensitive Highest”.
“Sensitive OFF”: No sensitivity
“Sensitive Low”: Low sensitive level
“Sensitive Normal”: Normal sensitive level
“Sensitive High”: High sensitive level
“Sensitive Highest”: The highest sensitive level
5.5.2. Record Time
To set the motion’s record time as 5sec, 10sec, 15sec, 20sec, 25sec,
30sec, 45sec, 60sec, 90sec, 120sec, 150sec or 180sec
5.5.3. Alarm Mode
To set the motion detector alarm mode.
“Mute”: No beep whatever detecting.
“ Buzzer-Short”: Beep shortly by buzzer on main board when
detection is active
“ Buzzer-Long” : Beep long by buzzer on main board when detection
is active
“ Alarm-Short”: Beep shortly by speaker of system when detection is
active
“ Alarm-Long”: Beep long by speaker of system when detection is
active