VBrick 9000 Series, Руководство по началу работы

Страница: 58 / 80

48 © 2012 VBrick Systems, Inc.
Setting VBrick Parameters
Logging In
The first step is to connect to the VBrick appliance using whatever method is appropriate at
your site (e.g. Telnet, HyperTerminal, etc.). When logging in, you are prompted for a login
name and password. These credentials give you access to the VBrick and are typically
provided by an administrator. When the
vbrick>
prompt is displayed, you are successfully
logged in. The CLI shortcut commands are shown below.
Login: <username>
Password: <password>
VBrick#
Table 21. CLI Shortcut Commands
Beginning or Ending an Edit Session
To begin a CLI edit session, first login as explained above, and then enter the first two
commands shown below
using the same username you used to login to the VBrick. You only need
to do this at the start of an edit session or if someone has ended your edit session. Also, you
only need to begin an edit session to
set variable and table parameters—not to get parameters.
You can get parameters without starting an edit session. When your edit session is done, and
after you have applied or saved your changes, do an end edit. You can also use the Begin Edit
(
BE
) and End Edit (
EE
) shortcut commands shown in Table 21.

To begin an edit session:
VBrick# SVAR vbrickEditName=
VBrick# SVAR vbrickEditName=<admin>

To end an edit session:
VBrick# SVAR vbrickEditName=
Command Description
BE
Begin edit session
DEBUG
Generate a debug file if requested by VBrick Support Services.
EE
End edit session
ERRORS
Show configuration errors
GVAR
Get parameter
NT
Ethernet Network Configuration
QUIT
Logoff the CLI session
RESET
System reset
SAVE
Save configuration
SD
Set defaults
SFD
Set factory defaults
SVAR
Set parameter
WAIT
Delay for specified time