Page 3 / 6
Sensitivity of Motion Sensor
●
You can adjust the sensitivity of the motion sensor by using the “SENS”
selector located on the right side of the sensor head. (See Fig.5)
●
Adjust motion sensor sensitivity to HIGH (H), MEDIUM (M), or LOW (L) to
achieve desired performance.
●
Approximate range for each setting: 70 ft. (H), 50 ft. (M), 30 ft. (L).
1. TEST MODE (daytime and nighttime operation.)
●
●
2.
Modes
of Motion Sensor
Choose a mode by rotating the switch on the bottom of the sensor of the fixture.
(See Fig.5)
Note: When power is first applied, the light will be on and warm up lasts 30 seconds.
3.
PC MODE (nighttime operation only)
●
Note: You can adjust the CCT color (2200K~5000K) by using the CCT color (2200K ~5000K) knob on the
backplate. (See Fig.6)
220207
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 4
1. Gently grasp the light heads and tilt them up or down, left or right to
adjust the light coverage area. Keep the light heads at least 1˝ (25mm)
away from the sensor.(See Fig. 4)
2.
Keep the light heads 30˚ below horizontal to avoid water damage and
electrical shock.
Fig. 2
Fig. 3
Adjusting the Light Head:
Fig. 5
PC
1min
Test
30s
M
L
H
3min
Auto
MODE
SENS
TIME
Custom
3H
AUTO MODE (nighttime operation only)
Note: You can adjust the low-level brightness (0~50%) and CCT color (2200K~5000K) by using the
low-level brightness (0~50%) knob and CCT color (2200K~5000K) knob on the backplate (See Fig.6)
●
●
●
Select "AUTO" on mode switch, slide the Time switch to the desired shut-
off delay time setting
30s/min/3min
.
At dusk, the light turns on to
selected low level brightness (0~50%) and
CCT (2200K ~ 5000K).
When motion is detected, the light turns to full
brightness (5000K) and stays on as long as motion continues.
When the motion is no longer detected, the light will remain on at full
brightness (5000K), for the
predetermined time you set (30s/1min/3min),
and then automatically switch back to
selected low level brightness
(0~50%) and CCT (2200K~5000K).
●
At dawn, the light turns off automatically.
In "PC" mode, the light turns on at full brightness at dusk and remains on until dawn.
S
li
de the Time switch to the "Test" position.
T
he light turns to high-level brightness (5000K) when motion is detected, and stays on as long as the motion
continues.
Then it reverts back to low-level brightness (0~50%) and CCT color (2200K~5000K) as per setting
about 5
seconds after motion is no longer detected.
Low Level
0%
50%
Fig. 6