Spare Parts List:
Assembly Kit
6760MM (1 SET) for T0734
6761MM (1 SET) for T0735
The following parts are available for reorder if damaged or missing.
Page 4 / 4
Mounting Screw (B) Wire Connector (C) Bolt Nut (D)
Mounting Plate Unit (A)
Rubber Pad (E)
5 Year Limited Warranty
How can warranty service be obtained?
1-800-482-9235
Vaxcel warrants all of our products against defects in workmanship and finishes for one year following the date of shipment.
In addition:
●
Any product with an integrated motion sensor or dusk-to-dawn photocell is supported by a 5-year warranty for the
functionality of the product.
●
Any product with integrated LED modules is covered by a 5-year warranty on the LED functionality.
Exclusions: This warranty does not include the failure of products from extreme acts of nature; environmental conditions
not suited for the products intended use; operation in temperatures outside of the range specified in the instruction manual;
usage with improper power supply, power surges or dips. For coastal locations, some corrosion is considered normal for
the environment.
Vaxcel reserves the right to repair, replace or issue a credit for any properly installed product, provided it is returned per
RMA instruction. This warranty is limited to the cost of the product only and does not extend to transportation, installation
or replacement costs.
231011
A: 17-3/4"
B: 6-1/2"
C: 7"
B
C
A
The fixture may be installed in
shaded area.
Only need to relocate fixture.
No corrective action needed.
On cloudy or overcast days, the light
may stay on longer than anticipated.
Still on the manual override mode.
Turn off the light, then turn it on after 5 seconds.
False triggering caused by a heat
source, such as a heater, dryer vent,
or heated swimming pool.
Eliminate heat source or relocate fixture.
The knob is not set in any mode.
Rotate it again to the mode you want.
Day
Night
If the light
stays on
SYMPTOM
DAY/NIGHT
POSSIBLE CAUSE
SOLUTION
The light
comes on for
no apparent
reason
If the light
is blinking
Night
Night
False triggering caused by a heat
source, such as a heater, dryer vent,
or heated swimming pool.
Eliminate heat source or relocate fixture.
Passing cars and reflective objects
interfere with the sensor.
Relocate fixture.
Street or sidewalk traffic is triggering
motion sensor.
Adjust the "Sens" knob to reduce the sensitivity.
TROUBLESHOOTING (continued)
