Page 2 / 5
221031
Installation Steps
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit box.
Adjusting the Sensor Head:
1. Aim sensor head toward desired detection area, maintaining a
5° - 40° downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with controls facing
toward the ground.
2. You can move the sensor head up and down to change the coverage
area. (See Fig. 1)
Note: Range set too high may increase false triggering.
(See Fig. 2 and Fig. 3 on Page 3)
1. Install the mounting strap to the outlet box with the stamped word “FRONT” facing away from the outlet box, using
two mounting screws that best fit the outlet box. Back plate should sit flush against wall surface when secured.
(Choose one matching pair of suitable mounting screws from the 3 pairs provided)
2. Fixture wires thread through gasket, then attach the gasket into back plate.
3. Pull out the source wires from the outlet box. Make wire connections using wire connector as follows:
---Connect the black wire from the fixture to the “hot” wire from the power source. (black)
---Connect the white wire from the fixture to the neutral wire from the power source. (white)
Carefully tuck the wires back into the outlet box.
4. Attach the back plate of the light fixture to the mounting strap, secure it with the fixture mounting screw.
5. Push the decorative cover firmly into the fixture mounting screw hole on the light.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.
7. With silicone caulking compound, caulk completely around where the back plate meets the wall surface.
CAUTION: Be sure to caulk completely where the back plate meets the wall surface to prevent water from
seeping into the outlet box.
Sensor
Mounting Strap
Outlet Box
Wire Connector
Backplate
Mounting Screw
Fixture Mounting Screw
Light Head
FRONT
Decorative Cover
Gasket
PAR 38 Bulb Max.150W
(not included)
sensor
Fig. 1