Page 4 / 5
180412
Customization Options:
Shut-off Delay
● The shut-off delay is the length of time the light will stay at brightness after motion has ceased to be detected.
● You can set the shut-off delay by rotating the delay time knob arrow so it points to the desired time setting within
“TIME” range. To increase the shut-off delay, turn the knob clockwise. To decrease the shut-off delay, turn the
knob counterclockwise.
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. You may wish to
make adjustments when the season changes.
For best performance, gently clean the lens with a soft
cloth every 1 or 2 months to assure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above
the ground. At such a height, the fixture will provide a
detection distance of up to 70 feet at 77 degrees
Fahrenheit. (See Fig.6)
3. The sensor detects movement across a detection range
of 240 degrees. (See Fig.7)
4. The sensor will be more sensitive to motion across its
detection path than motion directly towards it. (See Fig.8)
5. To reduce possible nuisances, do not mount the fixture
near a heat source like an air conditioner, vent or furnace
exhaust, or in a direction facing any reflecting object or
other light source.
Note: To make sure the above functions operate properly, always keep the wall switch in the “ON” position
(including the daytime).
---The light comes on for no apparent reason :
1. Re-aim the motion sensor.
2. Decrease the sensitivity setting.
3. Do not use a dimmer or timer to control the light fixture. Replace the dimmer or timer with a standard on/off wall
---The light flashes on and off:
1. Reposition the bulb away from the motion sensor.
2. Reposition the motion sensor.
3. The motion sensor is in “TEST” mode and warm up.
Troubleshooting
---The light does not come on at all:
1. Make sure the wall switch and circuit breaker are on.
2. Make sure the wiring is correct.
3. Cover the sensor with dark color cloth to verify that the ambient light level is not too high.
CUSTOM SETTING MODE (nighttime operation only):
1) Do not use power switch/wall switch ( photocell mode), the light to turn on at dusk and off at dawn automatically.
2)
Set motion-sensor operation to go on at a specified time. Turn the wall switch “OFF”, and turn it “ON” twice within
3 seconds. The light will go into motion-sensor operation at the specified time every night. The light turns off
automatically at dawn.
For example, a homeowner wants to have the light stay on high-level brightness from dusk to 8pm. At 8pm, the
homeowner would like the light to go into motion sensor mode. To achieve this, the homeowner will, at 8pm, turn
the wall switch “OFF”, and turn it “ON” twich within 3 seconds. This sets the light such that every day, the light
will behave the same way.
To revert back to Default, turn the wall switch “OFF” and then turn it “ON” over 5 seconds again.
Note: You can adjust the low-level (0~50%) and high-level (50~100%) brightness by using the brightness switch
on the back plate.
5'
8.0'
12.0'
70'
Where you install your fixture is important:
Be sure the light is mounted straight on the wall
or eave; otherwise, the detection distance may
be limited.
Fig. 6
Fig. 7
Motion
Least sensitive
Motion
Most sensitive
Sensor
Fig. 8
240
°
