
Page 9 / 10
Spare Parts List:
The light will not come
on.
Turn the light switch on.
Replace the fuse or turn the circuit
breaker on.
Recheck after dark.
Re-aim the motion sensor to cover the
desired area.
Increase the “Sensitivity” setting.
The light fixture is operating normally
under these circumstances.
Verify the wiring is correct.
The light switch is turned off.
The fuse is blown or the circuit breaker is
turned off.
Daylight turn-off (photocell) is in effect.
The motion sensor is aimed in the wrong
direction.
The outside air temperature is close to the
same as a person’s body heat.
The circuit wiring is incorrect (if this is a new
installation).
The motion sensor may be installed in a
relatively dark location.
Problem
Possible Cause
Solution
The light comes on during
the day.
Mounting Screw X2
#8/32X1/2 in
Mounting Bracket Screw
Fixture Mounting Screw
Mounting Strap
Mounting Screw X2
#6/32 X1/2 in
Mounting Screw X2
#10/24 X1/4 in
Decorative cover
Troubleshooting
The following parts are available for re-order if damaged or missing.
160826
Assembly Kit
5569MM (1 SET) for T0274
5570MM (1 SET) for T0275
Range
Up to 70ft. (Varies with surrounding
temperature)
Up to 240º
29W
2600lm
120 VAC, 60Hz
Test, Auto, Custom setting
5s, 1min, 3min, 5min
Iphone 4S or newer running IOS 8.0 x or later.
Android v4.4 or later
Phone must also have Bluetooth version 4.0 or later
Sensing angle
Electrical load - LED
Lumens
Power requirements
Operating modes
Time delay
Mobile device requirements