PAGE: 6 / 9
Tighten blades to blade brackets by
using blade screws and washers.
Fig.13
Blade Screw
Washer
Blade Bracket
Blade
HI
OFF
U/L
D/L
MED
HI
OFF
U/L
D/L
LOW
NOTE: Before installing blade brackets
to the motor, please remove the
plastic inserts.
Remove the motor screws, plastic inserts
and washers from fan fixture set. Secure
blade brackets to the motor with washers
and motor screws.
Plastic Insert
Fig.14
Motor Screw
Blade Bracket
The slide switch on switch box sets direction
of fan rotation. Select the desired direction of
fan rotation. Push the slide switch left for
"Forward" and right for "Reverse”.
Note: Wait for fan to stop before
reversing the direction of blade rotation.
Fig.17
Slide Switch
Reverse
Forward
Fig.15
Connect the two terminals respectively
from the motor and the switch box.
Switch Box
Assembly without fan light
Make sure the lead wire of fan light
in switch box is sealed with a wire
connector exactly. Secure the switch box
cover with the switch box screws.
Fig.16
Switch Box
Screw
Fig.19
UP / L
DOWN / L
HI
LOW
OFF
MED
Install the battery (9V, included) into the transmitter.
Turn on the electric circuit.
Press "HI" button to
operate
the fan in high speed.
Press "MED" button to
operate
the fan in medium
speed.
Press "LOW" button to
operate
the fan in low speed.
Press "OFF" to turn the fan off.
Press and release the "UP/L" button quickly to turn
on/off the light.
Press and hold the "UP/L" button to adjust the
illumination of light with the dimmer switch.
Press and release the "DOWN/L" button quickly to
turn on/off the the light.
Press and hold the "DOWN/L " button to adjust the illumination of light with the dimmer
switch.
Note: This remote controller has a memory function setting.The fan will operate
at the same speed and the fan light will stay at the same brightness-level as the
last time the power supply was turned off.
Replace the fan housing inner bulbs
Screw
Fig.21
Open the inner light plate
of worse bulbs by screw driver.
Take off the worse bulb
and install the new one.
Secure the inner
light plate back.
4-4W Type B11 E12
LED Bulbs
(Included)
Install the transmitter wall bracket on
the wall with two screws and place
transmitter in it carefully.
Fig.20
Wall Bracket
Transmitter
Screw
Screw
Fig.22
4-4W Type B11 E12
LED Bulbs
(Included)
Fig.18
T
urn ON the electric circuit at the
main fuse or circuit breaker box.
231204