PAGE: 4 / 9
Motor Wires
Thread the motor wires through the
canopy, downrod stand cover and
downrod.
Installation Steps:
Hanger Pin
Downrod
Lock Pin
INSTALLATION INSTRUCTIONS
NOTE: The fan weight is 21.1 lb (9.6 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Hang the fan on hanger bracket, and
make sure the slot of hanger ball is
snapped into the chip of hanger
bracket exactly.
Note: For sloped ceiling installation,
make sure the slot of hanger ball
and the chip of hanger bracket is
face down.
Fig.1
Turn off the electric circuit at the
main fuse or circuit breaker box.
Remove the lock pin from hanger
pin and remove the hanger pin
from the downrod.
Fig.3
Tighten the two collar screws.
Slide lock pin into hanger pin
until it is locked into position.
Fig.6
Lock Pin
Collar Screw
Slot
Chip
Hanger Bracket
Fig.7
Loosen the collar screws out part
way. Insert the downrod into the
collar. Slide hanger pin through
holes of collar and downrod.
Fig.5
Motor Wires
Downrod
Downrod Stand
Cover
Canopy
Fig.4
Hanger Pin
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION IN THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF
IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
Washer
Safety Cable Hook
Drywall Screw
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Fig.5.
Fig.2
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Tighten the hanger bracket to the outlet box with two mounting screws.(
Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.
) Attach the safety cable hook to the ceiling with the drywall screw and
washer, and make sure the safety cable hook is covered by the fan canopy.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT"!
231204