PAGE: 5 / 9
Slide the canopy up to ceiling
and over the two screws on
hanger bracket. Rotate
canopy clockwise until tight.
Note: Adjust the canopy
screws as necessary until
the canopy is snug.
Hang the safety cable into the safety cable hook.
Fig.10
Hanger
Bracket
Hanger Ball
Receiver
7 .
1 .
5 .
6 .
2 .
3 .
4 .
Antenna:
DO NOT CUT
OR SPLICE
Safety Cable Hook
Safety
Cable
Fig.11
Fig.12
Canopy Screw
Hanger Bracket
Canopy
Make wire connections:
1) The Motor white (neutral) wire to the white (neutral) "To
Motor N" wire from Receiver with a
2) The Motor black (hot) wire to the black (hot) "To Motor L" wire
from Receiver with a
3) The Motor blue wire to the blue "For Bottom Light" wire from
Receiver with a
4) The Motor orange wire to the orange "For Upper Light" wire
from receiver with a
5) The white (neutral) wire from Outlet Box to the white "AC in N"
wire from Receiver with a
6) The black wire from Outlet Box to the black "AC in L" wire from
Receiver with a
7) The ground wire from Outlet Box to the green ground wire
from the Hanger Ball and the green ground wire from the
Hanger Bracket with a
Make sure all of wire connectors are connected firmly.
***Tuck all wire connectors and wires carefully up into the Outlet Box,
EXCEPT antenna, which should remain outside Outlet Box.
Fig.9
Move ground wires (a), outlet box wires (b), and
motor wires (c) away from the center of the hanger
bracket. Then slide receiver through hanger
bracket as shown. Antenna end first, until it is
placed in the center. Finally, cut motor wires (c)
to length needed for connections.
Code example:
1-ON 2-OFF 3-ON 4-OFF on both SUR
Switches.
Note: If you have two ceiling fans
with 2 remote control units, set 2
different codes for each set of
transmitter / receiver.
Both the transmitter and receiver have a 4-key
unit code on each SUR Switch (Fig.8) and by
default, all keys are pre-set to the "off" position.
This means that the transmitter and receiver are
already paired together. However, if you have
multiple fans and remote controls and want to
avoid interference between them, you can "pair"
other transmitters and receivers together by
adjusting the SUR switches, so the same
numbered keys are in the "ON" position
on both (Fig.8a).
Note: The ceiling fan may work abnormally
if there is interference from other remote
controls.
Fig.8
Transmitter
Receiver
Antenna
SUR Switch
SUR
ON
ON
SUR
Fig.8a
Hanger Bracket
Receiver
Antenna
231204