TIP
Automix tank so any detergent
not used can be poured back
into the bottle.
Assembling your upright
Push handle into
main body.
Press clean water tank
release button.
Line up tabs on water tank
cap with clean water tank,
twist clockwise to re-fit.
Pour required carpet/hard
floor detergent into tank.
Twist locking tab
clockwise to lock
into place.
Stretch hose (Some models
only) - Clip hose connector into
top hose caddy wrap hose down
and around bottom caddy, up and
around top caddy clipping other
end of hose into bottom caddy.
Turn handle lock dial
clockwise to lock in place.
Pull to remove clean
water tank.
Twist detergent cap anti
-clockwise to remove.
Line up tabs on detergent
cap with clean water tank,
twist clockwise to re-fit.
Hold locking tab
vertically, line up bottom
caddy (smallest of the
two) with black panel
on carport washer.
40C
Max
!
Line up SpinScrub hand
tool into SpinScrub caddy,
push until clicks into place.
Twist clean water tank cap
anti clockwise to remove.
Fill clean water tank
to ‘max’ fill mark.
Twist locking tab
clockwise to lock
into place.
Hold locking tab
vertically, line up top
caddy (largest of the
two) with back panel
on carpet washer.
Clip hose connector into top
hose caddy and wrap hose
down and around bottom
caddy. Clip the other end of
the hose into the opposite
side of top caddy.
Filling the water/detergent tank
Getting started
Using your machine
WARNING: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the nozzle is not in
contact with the carpet the float will shut off the suction on the carpet washer. You will be able
to hear if this has happened as the motor noise on the machine will increase. Once the float is
activated, empty the dirty water tank if full. If the dirty water tank is not full then turn off your
machine at the power switch and wait for the float to settle.