Using your machine
Emptying the dirty water tank
CAUTION:
Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Press dirty water tank
release latch, pull to
remove dirty water tank.
To re-fit, tilt dirty water
tank and line up onto
carpet washer.
Push back until
it clicks into place.
Pull and lift dirty water
tank clip to release lid.
Lift to remove dirty
water tank lid.
Empty dirty water over
the sink. Rinse dirty water
tank and lid under water
to remove dirt/ debris.
Clean the filter screen
located at the back of the
dirty water tank.
Empty and rinse out clean and
dirty water tanks and leave to
air dry before replacing.
Do not leave solution stored in
the tanks between uses.
IMPORTANT
