12
1
2
3
Belt or Brush removal and replacement
Unplug the vacuum cleaner from
the mains supply. Press the handle
release button and turn the vacuum
cleaner over so that the base lies
flat and face up. Use a screwdriver
to remove the four retaining screws
shown above.
Remove the nozzle guard.
Lift and remove the brush bar, then
slide the belt off the motor shaft
and dispose of it.
Place a new belt on the motor shaft
and then slip the brush bar through
the belt.
The belt should sit on the end of the
brush bar with no bristles against
the end cap. Re-fit the brush bar.
Ensure the end caps are in the
correct position. Rotate the brush
bar to check the belt is not twisted.
Replace the nozzle guard.
Align the tabs and re-fit the screws.
Phillips screwdriver required
nozzle guard
tabs
13
4
5
Rotate the locking ring 180º and
turn the turbo tool over.
Pivot the lower housing and then
remove and obstruction you find
underneath.
To reassemble ensure the tabs are
engaged and the pivot the lower
housing closed.
Removing debris from the
turbo tool
r VS-19TS Swift manual op.qxd 7/15/04 8:00 PM Page 6
