4
A
A
A
B
B
B
B
A
2
1
3
Attach caster supports and casters
Remove Wet/Dry vac lid and inner tank. Turn outer tank
upside down. Match letters (A or B) on bottom of cast-
er support with letters on wet/dry vac tank.
Align square tabs (1) on supports with rails (2) on tank.
Slide tabs on to rails until caster support (3) snaps in
place.
Insert support screw into hole nearest tank. Tighten
screw with a Phillips screwdriver.
3. Assembling the Wet/Dry vac
Insert inner tank
With inner tank duct toward drain side of outer tank,
align tab (C) on inner tank with slot (D) in outer tank;
slide inner tank into place.
Assembly
Fig.2
Attach Wet/Dry vac lid
Rotate lid latches (E) outward. With wet/dry selector
(F) toward drain side of tank, align ribs (G) on front of
tank with slots (H) on either side of hose inlets; place
lid on tank.
Rotate latches inward to lock lid in place.
Note:
For convenience in attaching and removing
the lid, finger holds are provided.
Vax VO-7000 D7 IL 10/19/04 3:35 PM Page 4
Repeat with remaining casters and screws. Turn the
cleaner tank up the right way.
Once in place, do not remove the float assembly.
NOTE:
The large filter cage and the float ball on
Wet/Dry vac lid are not removable parts.
Attach small float cage
Turn inner tank upside down. Place float ball over round
opening in bottom of tank. Snap tabs (A) on float cage
into slots (B) on tank.
B
A
Fig.3
E
F
G
H
E
Fig.5
D
C
C
Fig.4
