2. Safety Information
FOR HOUSEHOLD USE ONLY.
When using the carpet washer, basic safety precautions
should always be observed, including the following.
1.
Do not leave the carpet washer unattended when
plugged in. Unplug it from socket when not in use.
2.
To prevent electric shock do not use outdoors.
3.
Not to be used as a toy. Close supervision is
necessary when used by or near children or the infirm.
4.
Use only as described in this manual.
5.
Do not use with a damaged cord or plug. If the
supply cord and/or plug is damaged, they must be
replaced by the manufacturer, a Vax Service Agent
or similarly qualified persons in order to avoid hazard.
6.
Do not pull or carry by the cord, use the cord as a
handle, allow the cord to come into contact with
hot or sharp surfaces or close a door on the cord.
7.
Do not unplug by pulling on the cord.
8.
Do not handle the plug or carpet washer with wet
hands.
9.
Do not put any objects into openings or operate
with openings blocked, keep them free of anything
that may reduce airflow.
10. Keep hair, loose clothing fingers and all parts of
the body away from openings and moving parts.
11. Do not use the carpet washer on any glowing,
burning or smoking particles.
12. Do not use without the solution tank and dirty
water tank in place.
13. Turn off all controls before unplugging.
14. Do not use to pick up flammable or combustible
liquids such as petrol, or use in areas where they
may be present.
15. Keep the carpet washer on the floor.
16. Do not use an extension cord.
17. Do not attempt to remove blockages with sharp
objects as they may cause damage.
18. Store indoors put away after use to prevent
tripping accidents.
19. Using improper voltage may result in damage
to the motor and possible injury to the user.
The correct voltage is listed on the rating label.
20. A hazard may occur if the carpet washer runs over
the power supply cord.
NOTE:
Carpets should be dry vacuumed thoroughly
before washing.
NOTE:
If the supply cord is damaged, it must be
replaced by the manufacturer, a Vax service agent or
similarly qualified persons in order to avoid hazard.
Safety Information/Use & Function
3. Use & Function
Assembling the carpet washer
Fig.3/2:
Insert 4 lower handle/tool caddy screws (as
shown) and tighten until secure.
BACK VIEW
BASE
POCKETS
TABS
MID-SECTION
Fig.3/1
Fig.3/2
CORD
3
NOTE:
The carpet washer must be unplugged from
the mains socket outlet after use, and before cleaning
or maintaining the carpet washer.
IMPORTANT:
This carpet washer is not intended for
commercial use.
Fig.3/1:
Stand base in upright position. Push mid-section
onto base by aligning tabs on inside of mid-section with
the pockets on the base as shown in Fig.3/1.
Vax V-028 Range.qxd 27/4/07 13:26 Page 3
