Assembling your upright
Insert the back panel into
the floorhead
Twist the quick release
cord hook to release the
power cord
Insert the short end of the
hose into the tube at the back
of the machine and connect
the hose end to the floorhead
Push TurboTool holder
on to the handle and clip
TurboTool into position
Insert the lower quick
release cord hook into the
hole at the bottom of the
back panel
Choose your desired
carpet height or hardfloor
setting
Place the dirt container
onto the machine and push
until it clicks into place
Now take the small clip and
push it down between the
post motor filter cover and
back panel, over the quick
release cord hook to lock
into place
Insert the extension tube
into the handle
Plug in and switch on
your machine
Plug in your machine and
push ON/OFF button to
switch on
Attach hose clip to the
air inlet tube
Push handle into the top
of the machine until it
clicks into place
Lie vacuum cleaner on its
back exposing brush bar
Align Hard Floor Adaptor
with base of vacuum
cleaner, push until its clicks
into place
Don’t over fill the dirt
container to avoid clogging
your filter
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry before putting
back into the vacuum)
• Filters require cleaning at least every 3 months
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage
• When using the accessories always make sure the brushbar is switched to the off position
IMPORTANT:
When the vacuum cleaner is stood in the upright position or when using on stairs and the hose/tools,
the brushbar height adjust dial must be set to hard floor
Getting started
Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
How to use
Using the Hard Floor Adaptor
Apply the Hard Floor Adaptor for optimum results on hard floors.
The Hard Floor Adaptor can be used on any floor setting.
TIP
To ensure the Hard Floor Adaptor
is correctly fitted, the wheels
should be towards the back of
the floor tool when attached to
vacuum cleaner.
