12
MAINTENANCE & CLEANING
Hose self clean function
IMPORTANT:
Use the hose self clean function after each use to remove any water or debris left in the hose.
IMPORTANT:
The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the thermostat
will automatically turn the machine off. Switch off and unplug the machine. Check the machine for blockages and remove
before restarting your machine.
Press the wash tool release
button and pull to remove
the tool from the hose end.
Unscrew the cap and fill
the clean water/solution
tank with approximately
1 inch of warm water
(max 40°C).
Push the hose end into
the hose self clean port.
Press the clean water/
solution tank release
button. Lift and pull to
remove the tank.
Switch the machine on and
hold in place until the clean
water tank has emptied.
Do not squeeze the trigger.
Repeat as necessary.
Rinse the dirty water tank
and lid with warm water
(max 40°C) to remove
dirt/debris.
40°C
MAX
40°C
MAX
Screw the cap back on
and refit the clean
water/solution tank onto
the machine so it clicks
into place.
Press the dirty water tank
release button. Pull and
lift to remove the tank.
Lift the dirty water tank
clip and unhook to release
the lid.
Lift the lid to remove from
the dirty water tank.
Empty the dirty water
into the sink or toilet.