Cleaner won’t run
Vacuum won’t pick up/
loss of suction
Dust escaping from the
Vacuum
Cleaner won’t dispense
solution
• Power cord not firmly pushed into a
mains socket.
• Blown house fuse or tripped circuit breaker.
• Dirty water tank is full.
• Dirty water tank is not installed properly.
• Solution reservoir not installed correctly.
• Solution reservoir not installed correctly.
• Solution tank empty.
• Plug cord in firmly.
• Check fuse/breaker. Replace fuse or
reset breaker.
• Refer to page 10 for fitting information.
• See ‘Emptying the dirty water tank’.
• Replace the belt.
• Replace the brush roll.
• Remove obstruction.
• Refer “Important” notes on page 8.
• Empty dirty water tank.
• Refer to page 10 for fitting information.
• See ‘How to operate your cleaner’.
• See ‘How to operate your cleaner’.
• Fill tank see pages 5 and 6.
Troubleshooting
Problem
Possible Cause
Possible Solution
14
• Dirty water tank is not installed correctly.
• Dirty water tank is full.
• Broken or worn belt.
• Brush roll is worn.
• Nozzle/dirt passage is clogged.
• Float prematurely activated.
1
Handle
2
Clean solution reservoir latch
3
Clean solution reservoir
4
Dirty water tank latch
5
Dirty water tank handle
6
Brush roll
7
Dirty water tank
8
Dirty water tank lid
9
Vacuum and brush roll on/off switch
10
Handle screw
11
Power cord
12
Carrying handle
13
Quick cord release
14
Handle release pedal
15
Cord hook
16
Cord clip
17
Solution release trigger
Parts Checklist
3
Rapide V-025 Manual 4/2/08 10:15 AM Page 3