*
To purchase consumables and accessories, please visit
vax.co.uk
Getting started
CAUTION:
Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments,
or removing and emptying the dirt container.
IMPORTANT:
The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner
does overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the
vacuum cleaner off and unplug. Remove and empty the dirt container also check the vacuum cleaner for
blockages. Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please
wait 24 hours for the filters to fully dry before putting back into the machine). If the vacuum cleaner is blocked,
switch off and unplug before removing the blockage.
Assembling your vacuum cleaner
Using a crosshead
screwdriver, remove the
screw from the back of
the vacuum cleaner.
Slide the handle down
into the main body of the
vacuum cleaner.
Return the screw and
tighten, securing the
handle into the main body
of the vacuum cleaner.
Wrap the hose over the
hose guide. Line up tabs
on the lower hose
connector with the tabs
in the lower hose entry
point. Twist connector
clockwise and lock
into place.
Line up tabs on the upper
hose connector with the
tabs in the upper hose
entry point.
Twist connector clockwise
until clicks and locks
into place.
Attaching the TurboTool holder and TurboTool (Quicklite Pet only)
Line up TurboTool
holder with handle,
push TurboTool holder
onto handle until clicks
into place.
Line up TurboTool brush
into TurboTool holder,
push until it clicks
into place.
Place the 2-in-1 crevice tool
and dusting brush into the
tool holder.