Vax
V-015
4
use and function
3. Use and Function
Slide the handle onto the top of the main body of the
vacuum.
Insert double pronged hole cover into front screw holes
(located behind the carry handle.
Secure in place using the two long Phillips head screws
provided.
Assembly of the Hose:
Screw in appropriate end of the
hose into the hold in between the cord holders. Feed hose
through the base holding point, clip into side clip, loop over
top holding point (see Fig.3/1) and feed into hose
connector (see Fig.3/2).
Cord storage:
To neatly store the power cord, wrap
around the two cord holders and then using the clip (found
just below the plug head) attach to the cord itself.
To turn on the vacuum press the on/off switch located
midway up on the right hand side. Pressing this switch
again turns off the cleaner.
To adjust the angle of the main body push the release
pedal on the lower left side of the cleaner. This then frees
the movement of the unit for greater mobility (Fig.3/3).
To adjust the brush bar for improved cleaning on varying
surfaces, turn the carpet height adjuster to the
appropriate position. This is found on the base of the unit,
in the centre, above the brush bar window.
IMPORTANT:
When using the tools and the cleaner
is in the upright position, the adjuster must be set
to the highest position.
WARNING:
To avoid injury keep lose clothing, hair,
fingers an all other parts of the body away from the
moving parts (i.e. the brush bar) of the cleaner.
The accessories can be used with or without the
extension tube. To attach, remove the hose from the
machine (see Fig.3/4) and push the desired accessory onto
the end.
Fig.3/1
Fig.3/2
Fig.3/3
!
!
Vax V-015 User Guide.qxd 22/9/06 12:17 Page 4
