Vax MACH1 VMUB1900, Руководство пользователя

Страница: 5 / 12

www.vax.com.au
5
Operation
1. Plug the cord into an electrical outlet and turn on by
pressing the on/off pedal, located on the back left of the
cleaner.
To unlock the handle from the upright position press the
handle release pedal (2) down.
Move the handle to the desired position (a) for storage and
position (b) for normal operation. To clean under furniture,
press the release pedal again and use position (c).
Accessories
NOTE: This unit is fitted with a constantly rotating
brush bar. To avoid damage to your carpet, ensure
the unit is not left on the stair tread when using
the accessories.
1. Make sure the vacuum cleaner has been switched off and
is in an upright position. Remove the lower hose by twisting
and pulling away from the side connector.
2. Remove the hose from the hose holder.
3. For hard to reach areas when additional hose length is
required, use the extension wand. It fits over the end of the
hose handle.
4. Choose the accessory that suits your need or use the
hose alone.
5. To fit the attachments push them firmly on to the end of
the extension wand or hose handle. To remove the tool,
twist and pull apart gently.
a
1
2
b
c
WARNING: This cleaner has a constantly
rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE: Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage
to these surfaces if the customer fails to take notice of
this recommendation.