Cleaning the shroud
Press dirt container release
button and lift to remove.
Twist the shroud to remove.
MAX
40˚C
Hold dirt container over a bin and pull the
dirt release clip on the bottom of the dirt
container, allowing dirt/debris to fall out.
Tap the shroud over a bin to
remove any dirt/debris.
Rinse the shroud under water (Max 40°C).
Leave to dry for 24 hours or until fully dry
before placing back in the machine.
Emptying and cleaning the dirt container
IMPORTANT: Unplug and switch off vacuum cleaner before performing maintenance or troubleshooting checks
TIP
Don’t over fill the dirt
container to avoid blocking
the air flow through the
vacuum cleaner.
Raise brushes for carpets.
Choose an accessory.
Lower brushes for
hard floors.
Taking care of your machine
IMPORTANT: The base of the vacuum cleaner should always be positioned flat on the floor when starting and
in use. The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle
Unwind the power cord.
Do not pull further than
the yellow marker.
Attach accessory to
hose end.
If required use tool
connector.
Plug into mains and press
the on/off button to turn
the machine on.
For use on carpets, click rocker
switch forward. For use on hard
floors click rocker switch back.
Slide vent cover on
hose grip open to
reduce suction if
required.
Using your vacuum cleaner
Using accessories
TIP
Brushes on the floor head
should be visible when
using on hard floors.
Using your machine
