Changing the belt
Let’s talk technical
What to do if it goes wrong
Switch off your vacuum
cleaner at the main socket
and unplug. Unclip the 2
small wheels from the base
of the vacuum to enable you
to remove the screws from
behind. Note: The screw for
the height adjuster dial is
located here
Remove the 9 screws from
the base of the floorhead
cover
Remove the floorhead cover
Lift the brushbar from the
machine to remove the belt.
Note: To remove debris from
the brushbar see ‘Lets talk
technical’ on the previous
page
Place the brushbar through
the belt and hook the belt
onto the metal spindle
Once the belt has been
replaced attach the brushbar
back onto the vacuum
Replace the floorhead
cover, 2 small wheels and
height adjuster dial by
screwing back into place
• Check the ‘This pack contains’ panel on the box to make sure the part
is included with your machine
• There may be a blockage in the hose. Please remove the hose from
the vacuum cleaner, check and clear any blockages
• Empty the dirt container and clean filters.
Go to the ‘Taking care of your machine’
• The brushbar may not be turning. Go to my brushbar isn’t
turning below
• If the accessory/tool will not pick up, check and clear any blockages
• The plug may not be fully pushed into the electrical socket
• Check the fuse in the plug if this needs replacing, always replace with
a British 13amp fuse
• The motor thermostat may have tripped. If this has happened, unplug
the vacuum cleaner. Remove and empty the dirt container and check
the hose for blockages.
• Clean the filters and allow the vacuum cleaner to cool for
approximately 1 hour (if you have washed the filters you will need to
wait 24 hours for the filters to fully dry before putting them back into
the vacuum cleaner)
• The brushbar may be clogged, check the brushbar and clear any hair
or debris Go to ‘Let’s talk technical’
• The belt may be broken, Go to ‘Let’s talk technical’
Solution
Problem
Warning:
To reduce the risk of personal injury, unplug the vacuum before performing maintenance
/troubleshooting checks.
There is an
accessory missing
Why does my
vacuum cleaner
have no power?
Why won’t the vacuum
cleaner pick up?
My brushbar
isn’t turning?
