Twist the quick release
cord hook to release the
power cord
How to use
Assembling your upright
Before you begin cleaning
• Always switch off and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or
removing and emptying the dirt container
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the
thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to
fully dry before putting back into the vacuum)
• Filters require cleaning at least every 3 months
• If the vacuum cleaner is blocked, switch off and unplug before removing the blockage
• When using the accessories always make sure the brushbar is switched to the off position
IMPORTANT:
When the vacuum cleaner is stood in the upright position or when using on stairs and the hose/tools,
the brushbar height adjust dial must be set to hard floor.
Getting started
Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Insert the back panel into
the floorhead
Insert the lower quick release
cord hook into the hole at the
bottom of the back panel
Now take the small clip and
push it down between the post
motor filter cover and back
panel, over the quick release
cord hook to lock into place
Insert the short end of the
hose into the tube at the
back of the machine and
connect the hose end to the
floorhead
Attach hose clip to the
air inlet tube
Place the dirt container onto
the machine and push until it
clicks into place
Insert the extension tube into
the handle
Push handle into the top of
the machine until it clicks
into place
Plug in and switch on
your machine
Push turbotool holder
on to the handle.
Clip turbotool into position
Choose your desired carpet
height or hardfloor setting
Plug in your machine and
push ON/OFF button to
switch on
Don’t over fill the dirt
container to avoid clogging
your filter
TIP
To ensure the Hard Floor Adaptor
is correctly fitted, the wheels
should be towards the back of
the floor tool when attached to
vacuum cleaner.
Lie vacuum cleaner on its
back exposing brush bar
Align Hard Floor Adaptor
with base of vacuum
cleaner, push until its clicks
into place
Using the Hard Floor Adaptor
Apply the Hard Floor Adaptor for optimum results on hard floors.
The Hard Floor Adaptor can be used on any floor setting.
