TIP
Brushes on the floor head should
be visible when using on hard floors.
Assembling your vacuum cleaner
Press both buttons at end
of hose and insert into
hose entry point.
Unwind the power cord.
Do not pull further than the
yellow marker.
Insert hose grip into
telescopic extension tube.
Plug into mains and push
the on/off button to turn
your machine on
Press button on telescopic
extension tube and adjust
to required length.
Insert the other end of the
telescopic tube into the
floor head.
Before you begin cleaning
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner
off and unplug. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum
cleaner to cool for approximately 1 hour (if you have cleaned the filters please wait 24 hours for the filters to fully dry
before putting back into the machine).
Clean the pre-motor filter every time the dirt container is emptied and replace the post-motor filter every 12 months.
If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
IMPORTANT: The base of the vacuum cleaner should always be positioned flat on the floor when starting and in use.
The dirt container should be locked into place before lifting the vacuum cleaner by the carry handle.
Getting started
Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
WARNING: When unwinding the power cord do not pull further than the yellow marker.
Always switch off the vacuum
cleaner before connecting
or disconnecting the hose/
attachments, or removing and
emptying the dirt container.
WARNING
For use on carpets, click
rocker switch forward. For
use on hard floors click rocker
switch back.
Slide vent cover on hose grip open
to reduce suction if required.
Raise brushes for carpets.
Lower brushes for
hard floors.
Choose an accessory and push onto the
telescopic extension tube or hose.
The TurboTool connector must be
fitted on the hose when using the
TurboTool (some models only).
Using your tools
