Vax Air Lift Steerable UCPESHV1, Давайте начнем

Страница: 12 / 20

Press the dirt container
release buttons located the
side of the carry handle.
Lift the dirt container lid
release clip. In a hinge
like manor lift the dirt
container lid.
Tap the filter over a bin
to remove any dirt/debris.
Wash the filter under
running water (40
degrees max).
Leave for 24hrs or until fully
dry before replacing.
Pull the pre-motor filter tab
and remove the filter from
the dirt container.
Emptying and cleaning the dirt container
Cleaning the pre-motor filter
Taking care of your machine
IMPORTANT:
The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the thermostat
will automatically turn the machine off. Switch off and unplug the vacuum cleaner. Check the machine for blockages and
clean the filters . Wash the filters with warm water (40°C max) and leave for 24 hours or until fully dry before replacing into
the machine.
For best cleaning results, filters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed every
3 to 6 months (depending on the level of use). Don’t use your vacuum cleaner without all of the filters in place.
Pull and remove the
dirt container off the
vacuum cleaner.
Hold the dirt container over
a bin, press the dirt release
button to open and allow the
dirt to fall out.
24hrs
MAX
40˚C
TIP
Don’t over fill the dirt
container to avoid
blocking the air flow
through the vacuum
cleaner and replace
filters every 6-9 months.