14
NOTE
In an extreme case where the heat exchanger cleaning has been neglected
Flush as directed in the diagram using a pressure washer
without chemical additives and for
maximum 10 minutes to avoid complete saturation of the gaskets.
o
After flushing shake excess water from the heat exchanger and replace directly
o
Assemble in reverse order of removal
o
Do not use tools to tighten the thumb screws, if available lubricate threads with grease
(even olive oil can be used) This will make the thumb screws easier to turn by hand.
o
Once assembled switch the Fresh-r on and close the door
8.2 Annual Maintenance
Every year the filter needs to be replaced in order to keep the Fresh-r in optimum
performance.
To replace the filter, do the following:
o
Open the door.
o
Switch off
o
Remove the filter as described above
o
Remove the two wing nuts at the bottom and remove the filter brace
o
Release tension from the m8 countersunk nuts
o
Remove and replace the filter cartridge
o
Re- assemble - pinch top clamp tightly to the frame and tighten nuts, fit lower clamp.
o
Re-mount filter carrier to Fresh-r. Switch on and close the door
Figure 8 Rear side of filter after removal from the Fresh-r
