Vauxhall CORSA, Руководство пользователя

Страница: 186 / 321

184 Driving and operating
When the vehicle is stopped, press
START/STOP to switch off the
vehicle. The electric drive unit will
shift to P automatically.
The vehicle will not shift into P if it is
moving too fast. Stop the vehicle and
shift into P.
To shift into P, press the P button on
the selector lever.
To shift out of P:
1. Depress the brake pedal and
press the UNLOCK button.
2. Shift into the desired gear.
Reverse gear R
To shift in to R, the vehicle must be at
standstill and the brake pedal has to
be depressed. Press UNLOCK if
necessary and move the selector
lever to R.
Caution
Shifting into R while the vehicle is
moving forward could damage the
electric drive unit. Only shift into
R after the vehicle has been
stopped.
Neutral N
In this position, the propulsion system
does not transfer torque to the
wheels.
The vehicle is not designed to stay in
N for extended periods of time. It will
automatically shift into P.
Automatic mode D
This mode is for normal driving.
Automatic mode with one-pedal
driving B
In this mode, the vehicle speed is
significantly reduced by releasing the
accelerator pedal without operating
the brake pedal.
Use B when driving down steep hills,
in deep snow, in mud or in stop-and-
go traffic.
9 Warning
In the case of extreme
temperatures or if the high voltage
battery is almost fully charged, the
brake force of the engine braking
may be temporarily reduced. If the
braking force is not sufficient, the
driver has to be prepared to use
the brake pedal.
To activate B, select D and push the
selector backwards. To shift out of B,
push the selector again.
Free wheeling
In certain situations, e.g., in an
automatic car wash etc., it is
necessary that the wheels can move
freely when the engine is switched off.
To enable free wheeling, the vehicle
has to be stationary, the engine has
to be running and the driver's door
has to be closed.
Selector type A
1. Depress the brake pedal and
select N.
2. Within 5 seconds, depress and
hold the brake pedal, switch off
ignition and move the selector
forwards or backwards.
3. Release the brake pedal and
switch on ignition.