Vauni Globe, Руководство пользователя

Страница: 28 / 56

28 |
Vauni Globe © Copyright 2020 Vauni AB - All rights reserved
ENG
1. See that the hearth is completely extinguished, by checking that the regulator lid is closed,
and that the hearth has been allowed to cool for at least 15 minutes with the lid closed.
2. Check that the correct fuel is used. Vauni recommends that the hearth be filled from bioethanol packaged
in bottles of 1 liter.
3. Open the regulator lid completely. Start filling by holding the bottle to the burner’s opening, angled so
that the fuel flows in the burner’s length direction, from right to left or vice versa (Figure 7). Pour the fuel
carefully down into the burner strainer. If necessary, a funnel can be used as an aid. Add carefully until
fuel is no longer absorbed by the burner strainer. The fuel level must not exceed the bottom of the burner
strainer with more than maximum 1 mm (figure 8). Then the burner is fully tanked, which corresponds to
2 liters of bioalcohol.
Note! For safety reasons the fuel transfer occurs with some delay. To avoid over-filling the burner, it is
important to give the fuel time to settle downward. Be especially careful, therefore, during the last part of
the filling. Let the bottle drip a little over the opening before removing it.
4. Be careful to avoid all spillage – any spill should be wiped off with a piece of paper. If over-filling occurs,
use suitable utensils to remove excess fuel, so that the fuel comes level with the burner strainer.
The liner is sensitive to fuel spillage. It is therefore important that the filling is done carefully, and that a
dry rag or paper is used to wipe off the bottle immediately after filling. If spillage does occur despite this, it
should be wiped off immediately, since dried fuel can cause permanent spots.
4.2.3 Handling of spillage
Avoid all spillage as far as possible. Take good time when refilling. If an accident does occur, observe the
following.
Note! If this has happened, it is very important to carry out the following restoration procedure
– do not light the hearth before then!
1. Immediately wipe off the liner with a dry rag to avoid discolouring.
2. Take out the burner module.
3. Loosen the insert and lift it out carefully. Make sure that it does not touch the hearth’s inside, since there is
a risk of scratches and of chipping the granite disk.
4. Wipe up the collected fuel with a rag or the like. See that the whole space is completely cleaned.
5. Place the liner back in position.
6. Lower the burner module by following instructions in section 3.1 Assembly and installation, step 12. See
that the regulator lid is positioned correctly.
9
max 1
mm
8
7