EN
ENGLISH
3
CHARGING PROCEDURE
NOTE: Before using the tool, read the instruc-
tion book carefully.
1. RECHARGING BATTERIES
A] CHARGING THE BATTERY
To the Li-ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off by
means of a protective circuit: The chuck no longer rotates.
In a warm environment or after heavy use, the battery pack
may become too hot. Allow time for the battery to cool
down before recharging.
B] IMPORTANT NOTES FOR CHARGING THE BATTERY
The battery in your new tool is not charged when it leaves
the plant. Therefore it must be charged for 1 hour before
using the first time!
C] CHARGING (SEE A)
Plug the charger plug into a suitable mains socket, and the
indicator light will show green. Then insert the battery pack
into the charger, the indicator light will become red to red
to indicate that charging is taking place.
a.Connect the power cord of the charger with a wall socket
.The charger LED turn green
b.Slide the battery as far as it will go into the charger, by
inserting the battery terminal into the suitable opening of
the charger.
c.The charging LED turn red, and the battery three LEDS
start flashing continuously from one to another.
d.When with about 30% capacity, the battery three LEDS
start flashing continuously from one to another.
e.When with about 50% capacity, one battery LED keep
shining and two other LEDs start flashing continuously
from one to the other.
f.When with about 75% capacity, two battery LEDs keep
shining and the other LED start flashing continuously .
g.when finish charging, three battery LEDs keep shining for
about 10 minutes and then turn off.
After charging 30 min (2.0 Ah), the battery will be fully
charged. When fully charged, the light(a) will turn to green.
Unplug the charger plug form the wall socket, the tool is
ready to use.
¡WARNING!
When battery charge runs out after continuously
use or exposure to direct sunlight or heat, allow
time for the battery to cool down before re-charging to
achieve the full charge.
2. TO REMOVE OR INSTALL THE BATTERY PACK
(SEE B)
Locate button on front of the battery pack. Depress the bu-
tton to release and slide it out from the tool. After recharge,
insert back into the tool. A simple push and slight pressure
will be sufficient.
OPERATING INSTRUCTIONS
HANDLE MOUNTING POSITIONS:
Always make sure the handle is locked in the desired
position before operation.
Depending on the operations, you can set the angle of the
handle to a 45 ° or 90 ° position to the left or right. To rotate
the handle, press the direction button and turn the handle
as shown in the figure. The handle is locked in the 45 °
position. To rotate the handle to the 90 ° position, press the
direction button again and turn the handle further.
ACTION OF CHANGE
CAUTION:
- Before inserting the battery packs into the tool, always
check that the switch handle, the handle button, and the
push rod act properly and return to the “OFF” position when
released.
/ A /
/ B /
Steering button
Push rod
Switch
handle
Handle button
Содержание 48036
Страница 1: ...48036...
