VAT 64246-UEHC-0001, Инструкции по установке, эксплуатации и обслуживанию

Страница: 32 / 73

INSTALLATION Series 642
32/73 Edition 2013-08-22 603685EA
4.6 Initial operation
To enable the valve for pressure control setup steps 1 to 6 must be performed .
In case position control is required
only it’s sufficient to perform steps 1 to 3.
Setup steps Description
1 Power up
Turn on ex 24VDC power supply of valve (and external 15
VDC for sensor power supply if required).
Refer to chapter «Behavior during power up» for details.
2
Interface
configuration
Refer to chapter «Interface configuration» for details.
3
Valve
configuration
Basic configurations of valve must be adapted according to
application needs. Refer to chapter «Valve configuration» for details.
4
Sensor
configuration
Basic configurations of sensor(s) must be adapted according to
application needs. Refer to chapter «Sensor configuration» for
details.
5 ZERO
Compensation of the sensor offset voltage.
Refer to chapter «ZERO» for details.
6 LEARN
Determination of the vacuum system characteristic to accommodate
the PID controller. Refer to chapter «LEARN» for details.
Without LEARN the valve is not able to run pressure control.
4.6.1 Interface configuration
Interface configuration must be adapted according to application needs.
Default configuration:
OPEN input CLOSE input OPEN output CLOSE output
not inverted not inverted open close
Functionality of digital inputs CLOSE VALVE and OPEN VALVE must be selected.
These may be configured as ‘not inverted‘ or ‘inverted‘. Default is ‘not inverted‘.
LEARN range configuration for remote operation must be selected.
This may either be ‘full range’ or pressure limit according of analog SETPOINT input. Default is ‘full
range‘.
Local operation :
(‘Control View’, ‘Control Performance Analyzer’
or ‘Service Box 2‘)
Remote operation :
Do configuration in menu ‘Setup / Interface’.
It’s not possible to do ‘Interface configuration‘ via
remote operation.