13)
Belt Tracking
(Move in small increments while belt is moving. Do not leave
conveyor running unattended.)
•
If the belt is slipping, add belt tension by raising equally both
sides of aligner roller.
1”
-
2”
of belt sag at the bottom side is
desirable. To raise the roller turn aligner bolt clockwise.
•
Belt moving to the left
, raise left side of aligner by turning
aligner bolt clockwise 1/2 turn at a time.
•
Belt moving to the right
, raise right side of aligner by
turning aligner bolt clockwise 1/2 turn at a time.
•
If belt is tracking off center at the drive roller, slightly loosen
bearing bolts, (2)
1/2”
wrenches needed. Turn adjustor screw
clockwise to move belt toward motor end of pulley and coun-
ter clockwise to move belt away from motor end of pulley,
retighten all bolts. Recheck belt tracking at front end.
Note: Do not over
-
tighten belt,
1”
to
2”
belt sag is desirable.
Belt aligner pulley
Aligner Bolt
Conveyor Front End
Drive roller adjustor
Adjustor screw
Bearing bolts
Conveyor Rear End
13
13
10)
Plug the wire from the conveyor motor into the rear of the control box.
11)
Turn on the system switch and then the belt speed control. See
Dryer Operation–
Startup Procedure
. Check that
the belt is moving and running in the center of both pulleys. If belt is tracking in the center of the pulley, dryer is
ready for use. If tracking is required, see below.
Assembly
(cont’d)
12)
Have a licensed electrician test the shops voltage at the machines disconnect, for shops with less than 240V service,
it is necessary to auto tune your controller. This procedure can be found in the
Troubleshooting
section on pg. 14.
Please record your shops actual voltage here:______________________
Do not tighten this nut!
Pg. 6
