Vasco IDENTIKEY AG-3 Series, Руководство по установке

Страница: 16 / 54

aXsGUARD Gatekeeper Installation Guide v2.7
Connecting the aXsGUARD Gatekeeper to a Network
2.
Connect the aXsGUARD Gatekeeper via the power cable to a supply. The AG-7XXX models have two
power units, each with a separate power cable. These power cables need to be connected to separate
power circuits. The second (redundant) supply provides backup in case the fuse for the supplying power
circuit fails.
3.
Power up the aXsGUARD Gatekeeper by pressing the power switch once (see image below). A green LED
lights up.
4.
To check the network is correctly connected, you can verify whether a green light shows at the socket
where the network cable is plugged in. If a green light is not visible, check that the network cable is in
good working order and correctly plugged into the device labeled as 'eth0' on the aXsGUARD Gatekeeper
and your network hub or switch.
4.3 Connecting to your Network
Installation of the aXsGUARD Gatekeeper requires temporarily isolating a client workstation from the network
and linking it to the aXsGUARD Gatekeeper. This involves changing a client workstation IP address to within the
specified IP address range for the aXsGUARD Gatekeeper. During the first-time configuration, the aXsGUARD
Gatekeeper IP address is modified to within the range of your network (we explain how to do this in section
9.6.1 ). The client workstation network settings can then be restored.
The aXsGUARD Gatekeeper is delivered with a default LAN configuration as follows:
IP address / Netmask 192.168.250.254/24
Network Host Name axsguard
Domain Name domain.be
DHCP Server Disabled
4.4 Workstation TCP/IP Settings
To access the aXsGUARD Gatekeeper, a workstation needs to be temporarily configured with the same TCP/IP
settings as the aXsGUARD Gatekeeper.
1. Configure a workstation with the following settings:
IP address 192.168.250.1
Subnet Mask 255.255.255.0
Gateway 192.168.250.254
DNS Server 192.168.250.254
©
August 2010 - VASCO Data Security 16
Image 8: Power Button and Power LED