18
Vasco
Kruishoefstraat 50
3650 Dilsen-Stokkem
Belgium
Tel.: +32(0)89790411
__________________________________________________________________________
1.
Introduction
The preheating element is specified for installation in a Vasco ventilation system. In mutual
operation, it enables outside air to be heated to a desired target temperature. The max. target
temperature is limited by the max. heating power of the preheating element and depending on the
supplied air temperature and flow rate. Since this serves as a preventive device, it has no on/off
switch. The resident must ensure in case a power plug on the appliance is present this is always
plugged into the socket and that the socket is live.
2.
Safety
Electrical components
Only the professional installer is authorized to install the preheating element. The installer must
use the appropriate tools for each work. The electronic components of the preheating element
may be under electrical voltage. Do not touch the appliance during employment, risk of burns and
fire. In the event of a defect, contact a professional installer and have repairs carried out only by
expert personnel.
Safety instructions
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they are supervised or
have instructions regarding the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance. Children of less
than 3 years old should be kept away unless continuously supervised. If the power cord is
damaged, it must be replaced by the manufacturer, after-sales service or persons with similar
qualifications to avoid danger. The user is responsible for the safe disposal of the preheating
element at the end of its service life, according to the locally applicable laws or regulations. You
can also return the appliance to a collection point for used electrical appliances.
Maintenance
The preheating element should be periodically inspected for contamination. Before inspection,
the ventilation unit and in case of relevance the preheating element must be switched off by
removing the power plug(s) from the socket(s). The preheating element contains heated parts. If
you unplug the appliance(s), the appliance will remain hot, so wait approx. 10 minutes after
removing the power plug(s) for the preheating element to cool down.
Make sure that the power plug(s) cannot be plugged back into the socket(s) by anyone else
before you have finished your work. Do not insert the power plug(s) into the socket(s) until the
preheating element and all parts are installed.
Guarantee
Vasco is not liable for damage caused by failure to observe the safety instructions or by not
following the instructions in the manual. The warranty conditions can be found on page 23 of this
manual.
