X-Series All Weather User Guide 17 150-092
3.2
Installing the TSHARC™ Driver (Cont’d)
Multi-Monitor (multiple display driver card)
This screen will allow you to set up separate touch screens on different touch screen
displays that are configured with separate display driver cards.
1. Select the location of your primary touch screen
monitor. Then select OK
2. Select the location of the next touch screen monitors
position relative to the primary monitors already
defined.
3. Recalibrate your system. It is important that you
recalibrate your touch screens based on the new
monitor configuration you have defined.
Correcting for skew
The TSHARC touch screen controller drivers allow the user to adjust for a touch screen
that has been incorrectly registered to a display. After you have calibrated your touch
screen as accurately as possible you can check to make
sure the touch screen calibration is “Square” to your
display. Select run from the “Adjust Skew” portion of
the calibration tab.
The display will bring up a window that will graphically
display your X and Y registration. When the red and
green dotted lines are aligned to the solid square lines
of the display. You may use the buttons on screen or
the arrows on your keyboard to adjust the skew.
Right Click - Event Area
Since the majority of touch applications do not utilize a right click mouse function, the
default settings do not allow for a right mouse button click.
1. You must enable this feature by selecting the “Enable right mouse button” radio
button. Once you have enabled the right click function, you will invoke a right click by
touching and holding a single point on the touch screen for a defined period of time.
2. Define the amount of time needed to evoke a right click function. Make sure to set
the time long enough to insure that a right mouse click only happens when desired.
Generally, one second will be sufficient.
3. The right mouse button and double click event area is the physical touch area in
which the events must take place. This should be set to 1/2” or larger to insure that
your user can accurately touch the event area with their finger.
NOTE: If you are using your touch screen for drawing or writing. Should minimize the
event area and disable the right click function.
