POWEG3010
EN
Copyright © 2021 VARO
P a g e
|
7
www.varo.com
8.1.1
Cold starting
If the engine is cold or if it has been stopped for more than 5 minutes or if fuel has been added
to the engine.
▪
Push the primer pump gently (7 to 10 times) until fuel begins to flow into it. (Fig. 1)
▪
Move the choke lever (4
) to position “CLOSE /
” (Fig. 2)
(a) choke lever
(b) open
(c) close
▪
Set the ignition switch to the “START” position. (Fig. 3)
▪
Hold the unit down firmly so that you will not lose control while cranking the engine. If not
held down properly, the engine could make you lose your balance or swing the cutting
blade into a nearby object or your body.
▪
Pull out the starter handle slowly (10 to 15 cm), and check the pressure. Pull strongly
when you feel the pressure and start the engine.
▪
When the engine starts, return the choke lever to ”OPEN /
".
▪
Run the engine for approximately one minute at a moderate speed before moving up to
full speed
Note: When restarting the engine immediately after stopping it, leave the
choke open.
Note: Overchoking can make it hard to start the engine due to excess fuel. If
the engine fails to start after several attempts, open the choke and pull the
rope again, or remove the spark plug and dry it.
8.1.2
Hot starting
Restarting immediately after the engine has stopped. If the engine does not start, repeat the
above steps
Do not pull the rope to the end or return it by releasing the knob. This can
cause starter failures.
8.2
Stopping the engine
▪
Release the throttle lever completely.
▪
Move the engine switch to the “STOP” position. The engine will now slow down and stop
(Fig. 4)
Note: If the engine does not stop after moving the switch, close the choke to
make it stop.
8.3
Angle change of rear handle
To permit vertical operation of the unit, the angle of the rear handle can be changed. To
reduce fatigue when trimming hedges, the handle can be swivelled 45° or 90°to the left or to
the right.
8.3.1
How to change the angle (Fig. 5)
▪
Push back the throttle lever, and rotate the rear handle, pulling the adjustement trigger.
▪
Rotate the rear handle 90 or 45 degrees to the right or to the left.
▪
After completing the rotation, release the adjustment trigger To secure the rear handle,
hold the adjustment trigger gently with one finger
