POWDP15100
EN
Copyright © 2020 VARO
P a g e
|
11
www.varo.com
For maximum performance, use high speed steel bits for metal or steel drilling. Turn the
torque adjustment ring on the drill to desired torque setting. Begin drilling at a very low speed
to prevent the bit from slipping off the starting point. Maintain a speed and pressure which
allows cutting without overheating the bit.
Applying too much pressure will:
▪
Overheat the drill
▪
Wear the bearings
▪
Bend or burn bits
▪
Produce off-center or irregular shaped holes
When drilling large holes in metal, it is recommended that you drill with a small bit at first, then
finish with a large bit. Also, lubricate the bit with oil to improve drilling action and increase bit
life.
11 CLEANING AND MAINTENANCE
11.1
Cleaning
▪
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪
Regularly clean the machine housing with a soft cloth, preferably after each use.
▪
Keep the ventilation slots free from dust and dirt.
▪
If the dirt does not come off use a soft cloth moistened with soapy water.
▪
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
11.2
Maintenance
▪
Our machines have been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper machine care
and regular cleaning.
12 TECHNICAL DETAILS
Model No.
POWDP15100
Chuck
13 mm keyless
Power supply
20 Volt DC
Gear Train
2 Speed
No Load Speed
0-450/0-1800 min-1
Clutch
23+1 Positions
Torque
50Nm (MAX.)
13 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
76 dB(A)
Acoustic power level LwA
87 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration)
Max 2,9 m/s²
K = 1,5 m/s²
14 WARRANTY
▪
This product is warranted for a 36-month period effective from the date of purchase by the
first user.
▪
This warranty covers all material or production flaws excluding : batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
