POWC30100
EN
Copyright © 2021 VARO
P a g e
|
7
www.varo.com
9
USE
▪
Hold the machine firmly and move it against the workpiece. Move the grinding disc evenly
across the workpiece.
▪
Move the machine during roughing under an angle of 30º - 40º across the workpiece (fig.
6).
Never use grinding discs for roughing!
▪
Inspect the grinding disc regularly. Worn discs have a negative effect on efficiency of the
machine. Replace the grinding disc on time.
▪
Do not put the machine down when the motor is still running. Do not place the machine on
a dusty surface. Dust particles may enter the mechanism.
▪
Always switch off the machine first before removing the plug from the wall socket.
Never use the spindle lock to stop the motor.
10 CLEANING & MAINTENANCE
10.1
Service
▪
Only qualified specialist personnel and original replacement parts should be used for
repairs. This will ensure that your device remains safe.
▪
Damaged switches must be replaced by our after-sales service department.
▪
If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
10.2
Cleaning
▪
Regularly clean the machine housing with a soft cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt. If the dirt does not come off use a soft cloth
moistened with soapy water. Never use solvents such as petrol, alcohol, ammonia water,
etc. These solvents may damage the plastic parts.
10.3
Lubrication
The machine requires no additional lubrication.
11 TECHNICAL SPECIFICATION
type
POWC30100
Voltage
230-240V
Frequency
50 Hz
Power input
500 W
No-load speed
11000/min
-1
Disc diameter
115 mm
Spindle dimension
M14
