The heat pump can be installed
in a corner but notice there
should be enough space for
water connections depending on
a new installment of water pipes
or for the existing water pipes.
Applicable for both VT100C and VT180C
Applicable for both VT100C and VT180C
Applicable for both VT100C and VT180C
Applicable for both VT100C and VT180C
For installation in a closet please
make sure that ductings are
installed to ensure enough air
flow into the heat pump. Failure
of doing so can cause exclusion
of warranty.
State-of-the-art building regula-
tions, standards and legal
requirements must be observed.
Unused connectors (Coil,
recycling loop) have to be sealed
and insulated properly in order to
avoid heat losses.
CHOICE OF THE INSTALLATION LOCATION
Wherever possible, the heat pump should be installed close to
the existing hot-water conduit.
The location must be indoors in a frost-free environment with
a frost protected sewer drain. The floor at the location must be
flat and at level. It has to support the weight of the DHW HP
(approx. 200 Kg for VT100C and 300 Kg for VT180C filled).
The location must be designed to support the corresponding
load. If the HP will operate mostly on, off peak hours do not
install the product near to bedrooms. Even if the DHW HP
operates very silently, this might disturb sensible users. Please
ensure that the location and the DHW HP are easily acces-
sible for maintenance and service. All damages and service
impossibilities (e.g. repair), due to the reduced accessibility are
part of the installer/user responsibility and not covered by the
manufacturer’s warranty.
INSTALLATION
ENGLISH
10
