22. The printer should appear as below.
Install the Re-Feed Preventer
23. Locate the 2 re-feed preventer mounts on the
scanner input platen on the front of the printer.
24. Clip the 2 re-feed preventers into position on the mounts.
Remove Tape and Prepare Machine
25. Remove the orange tapes from the top, front end, and
rear of the printer. Remove all the protective film from the
front panel and the printer’s surface.
Attach Printer to Stand
Important
Make sure that the stand and printer are in the correct
position for assembly.
20. Place the printer onto the stand, lining up the triangles on
the supports to match up with the ones on
the bottom of the printer.
21. Fix the printer to the stand from underneath.
First insert the 4 black screws, and then tighten them.
Note:
When attaching the printer to the stand, insert the second
screw in to the opposite end of the printer so that the
holes line up easier.
Perfecta
®
STP Series
Assembly Instructions
Page
5
