12. Insert 2 black special screws and nuts into both sides of
the leg (4 total), and tighten by hand.
Note:
If it is difficult to insert the screws; go back to the previous
step, and check the supports are well in place.
13. Tighten the 4 screws by hand (2 each side).
14. Fully tighten the 4 screws (2 each side) with the
hex screwdriver, holding opposite side in place.
15. Check the 4 wheels are locked.
Remove Printer Packaging
16. Open the printer box.
17. Remove the tapes from the film, then remove the
tray and box.
18. Remove the tapes from the endcaps, and
remove the packing pieces.
19. Uncover the printer by cutting open and
pulling down the plastic bag.
Perfecta
®
STP Series
Assembly Instructions
Page
4
