vario helicopter Heli Lights, Руководство по эксплуатации

Страница: 8 / 12

8
LIght controL fEAturES
• Powerful programmable LED microprocessor and light sequencer
• Wide input voltage range from 6 - 42 volts (2-10S LiPo packs)
• All battery types are supported
• 5V supply needed by the LED modules is done within the light controller
• Power supply is separate from that of the receiver to protect the recei -
ver /servos from any possible short circuit of the LED modules
• Up to 3A current possible
• 10 pre-programmed flash patterns including rotating beacon simulation
• Receiver supply voltage: 4V - 13V
• Receiver supply current consumption: 100 mA
• LED supply voltage: 6V - 42V, LED power output: 5V, 3A max
• Dimensions: 75 x 24 x 17 mm, Weight: 35 g
• All systems are fully inspected and tested before packaging,
to ensure that all units operate to specifications.
MountIng
• With double-sided adhesive tape or velcro OR
• With the supplied rubber grommets and mounting tabs. Carefully push
the rubber grommets into the tabs and mount the tabs on each side of
the housing, securing them with a small drop of super glue
• To avoid the possibility of radio interference, please do not place the
light control or its wires too close to receivers or antennas
connEctIng thE LEDS
• 3 slots/pins for Navigation lights (continuous light)
• 2 slots/pins for Anti-Collision (Strobe Lights)
• 1 slot/pin for Landing Lights (can be switched on/off while all other
lights remain on)
• Plug all wire cables in with the black wire (-) pointing upwards towards
the upper face side of the Control module
Status LED
Control dial
Navigation 1-3
Landing light
ACL / Strobe 2*
ACL / Strobe 1*
Power cables
Receiver cable
*different flash patterns available