13
a
djuStInG
of
bowl
ClamPInG
and
CenterInG
erGo140
and
ar200:
In the rear part of the bowl arms
(J)
a shaft with an eccentric stud
(K)
has been mounted, on which the ball bearing is mounted.
By turning the eccentric stud, the bowl arms can be opened and closed so that the clamping and the centering of the bowl
can be adjusted. It has to be observed that the shaft is mounted in the bowl arm with a thread so that when the eccentric stud
is turned, the whole shaft is turned out and in into the bowl arms. When exchanging the whole shaft, the right starting point
for the adjustment must be found first. The ball bearing
(L)
must be in the middle of the guide plate (M) so that the width of
the entire ball bearing is fitting tightly against the guide plate, and at the same time it has to be observed that the eccentric
stud cannot hit the back plate when the adjustment has been finished.
In order to counteract that the eccentric shaft turns loose by itself when the mixer is working, the eccentric shaft must be
self-tightening. In order to obtain this effect, the below drawings must be followed, on which the adjusting area for the left and
the right bowl arm, resp. is shown.
First find the bowl centering, e.g. by mounting bowl and beater in the mixer, and turn the beater round with your hand, and
measure the distance from the beater to the edge of the bowl.
• When adjusting the clamping and centering of the bowl,
the bowl arms must be raised into working position. When
exchanging the shaft with eccentric stud
(K)
the bowl arms
must be lowered.
• First open the lock plate
(N)
.
• Loosen the shaft counter nut
(P)
, use span 46.
• Screw an M8 bolt with counter nut
(R)
into both the eccentric
studs
(K)
, and tighten the counter nuts. If the shaft with the
eccentric stud has stuck in the bowl arm, it can be loosened
with a key with the span 36.
• By turning the eccentric studs the clamping and the centering
of the bowl can be adjusted.
• Remember to use the right adjusting area for right and left
bowl arm. The drawings show the adjusting area for
•
When the adjustment is correct, tighten the shaft counter nuts
(P)
. Hold the bolt
(R)
while the shaft counter nut is tightened.
• Knock the lock plate
(N)
in position.
• Remove bolt and counter nut
Movement of
the bowl arm
Adjusting area for right bowl
arm, seen from behind.
Loose bowl
clamping
Tight bowl
clamping
Tight bowl clamping
Movement of the
bowl arm
Loose bowl clamping
Adjusting area for left bowl
arm, seen from behind.
Adjusting diameter
(Y) = 607 mm
Содержание ERGO100
Страница 14: ...14 Electrical components...
Страница 15: ...15 Safety circuit...