11
Error codes:
If the mixer is overloaded, the motor will stop and
will be shown for ‘over load’ in the display.
•
Allow the mixer to cool down.
•
After a short time, the display will change to normal mode.
•
The mixer can be started again.
List of errors:
In case of other errors, contact the supplier.
Possible solution:
A rattling sound from the closed part of the mixer.
Adjustment of special v-belt
The mixer starts “striking” when kneading dough Adjustment of special v-belt
which normally causes no problems.
The mixer changes its speed by itself.
Adjustment of special v-belt
The minimum and the maximum speeds are changing.
Adjustment of speed.
The bowl is too tight or too loose.
Adjustment of bowl fixing
The tool hits the sides of the bowl.
Adjustment of bowl centering
The tool hits the bottom of the bowl.
Adjustment of bowl height
•
See also the section
“Start-up after stop at high speed”
on page 6.
Electrical Fuse:
The machine is protected by a fuse. The fuse is built into the back
of the control panel.
