Varifan CM10-2, Руководство пользователя

Страница: 7 / 16

Page 7
INSTALLATION
2.3.4 - Connecting to a MSC and an IC
•
Install an 18 AWG cable pair between the CM10-2,
the MSC and the IC. The cable can extend to a
maximum length of 500 feet (150m).
•
Connect one end of the cable to the (+) and (-)
terminals of the CM10-2 low voltage terminal block.
Refer to the bottom left corner of figures 1 or 2.
Refer to your MSC or IC manual for further connection
procedures.
2.4 POWERING UP
Before powering up the CM10-2, attach the faceplate to
the casing of the control panel using the four screws
previously removed.
To test the unit independently of the MSC or the IC, set
the two toggle switches located on the front of the unit
to (
ON ). Fans 1 and 2 should both operate. If they do
not, refer to the Trouble Shooting section in the
appendix of this document.
When you have completed verifying fan operation set
both toggle switches to
AUTO .
www.monitrol.com