Block Valves: Instruction Manual for All Sizes
1-4
D
R
A
FT 9/
21
/04
1.1.1 Electrical Connections to Solenoid
To supply power to the solenoid:
1. Remove the connector from the solenoid by removing the holding screw and pulling the
connector away from the solenoid.
2. Remove the terminal block from its housing by inserting a small, flat-head screwdriver
in the slot provided at the terminal base and prying the housing off (Figure 1-2).
Figure 1-2
Solenoid Assembly
3. Feed the power line through the housing grommet and connect the three leads to the
terminal contacts which are clearly labeled 1, 2, and
(ground).
4. Push the terminal block back into the housing and snap it in place.
NOTE
The housing can be rotated 360° in 90° increments so that the
power line exits the connector in the most convenient
direction.
5. Plug the connector back into the solenoid and tighten the holding screw.
Holding Screw
Housing Grommet
Terminal Block
Housing
Содержание L6280
